Safety Instructions - Electrolux WS 210 Benutzerinformation

electrolux 44

Safety Instructions

Warning! Before
appliance compare the power data
(voltage and frequency) indicated on
the characteristics plate with those of
the power supply in question. If these
data do not match there may be
problems. In case of doubt, contact an
electrician.
Warning! If the electrical wire plug is
removed, the appliance must
installed and
technician.
electrician who knows and respects
current safety
manufacturer
responsible for damage resulting from
fitting or connecting errors.
Warning! The electrical safety of the
appliance can only be guaranteed if it
is earthed. The manufacturer cannot
be held responsible
resulting from the absence of or
defects in the installation‟s protection
system (e.g. electrical shock).
Warning! Only use the appliance once
it has been fitted into its built-in
position. Only in this manner can it be
guaranteed that users cannot access
the electrical components.
Warning! Never
appliance‟s frame. Possible contacts
with electrical conducting parts or
changes to electrical or mechanical
components may
connecting
connected
Contact a qualified
standards.
cannot be
for damage
open up
represent a danger to users‟ safety
the
and prejudice the correct working of
the appliance.
Warning! Repairs and maintenance,
especially of parts carrying electrical
current,
technicians
manufacturer. The manufacturer and
retailers
responsibility
be
caused to people, animals or property
by a
as a result of repairs and maintenance
carried
personnel.
The
Warning! Repairs undertaken during
held
the guarantee period must only be
done by technicians authorised by the
manufacturer. If this is not the case
then any damage resulting from the
repair in question is excluded from the
guarantee.
Warning! The appliance must be
disconnected
current when installation and repair
work is being done. To disconnect the
appliance from the current, one of the
following conditions must apply:
- The
breakers must be disconnected.
the
- The plug should be removed from the
socket. To remove the plug from the
socket do not pull on the electric cable
but rather pull out the plug itself
directly.
must only be
authorised
do not
for any
out by non-authorised
from the
switchboard fuses
done by
by the
accept
damaged
electrical
/ circuit