General Control; Auto Power Off Function - Sharp DK-AP8P Bedienungsanleitung

General control

ON/STAND-BY
MENU
ON/STAND-BY
ON/STAND-BY
■ To turn the main unit power on
Press the ON/STAND-BY button on the main unit or touch
ON/STAND-BY pad on the remote control. The POWER and
E indicator will turn on.
SOUND
After use:
Press the ON/STAND-BY button on the main unit or touch the
ON/STAND-BY pad on the remote control to enter the power
stand-by mode. The POWER indicator will turn off.
Note:
This unit consumes low current during stand-by mode. However,
please remove the batteries if the unit will not be used for a long
period of time.
E SOUND
TV DISPLAY SHUFFLE
E SOUND
ENTER
SHUFFLE
E
SOUND
■ Volume control
Press the VOLUME (+ or –) button on the main unit or touch
VOLUME (+ or –) pad on the remote control to increase or
decrease the volume.
POWER indicator will be blinking when the volume reaches
maximum or minimum level.
■ E
control
SOUND
When the unit is turn on, the E
orange. You are now in the E
SOUND
high frequency are automatically adjusted according to the
volume input.
To turn off E , press the E
SOUND
touch the E pad on the remote control. The E
SOUND
indicator will go off.

■ Auto Power Off function

If no iPod or iPhone is docked and there is no audio cable
connected to AUDIO IN terminal, the unit will enter the power
stand-by mode after 5 minutes of inactivity.
■ To activate the remote control unit
Touch either the ON/STAND-BY or E
one second. The ACTIVE indicator will blink twice and light up in
red, indicating that it is ready to be used.
Remote control will be inactive (ACTIVE indicator turns off) if left
idled for about 8 seconds.
Repeat the above process in order to reactivate the remote
control unit.
Remote control operation:
The function will only operate once the finger is removed from
the touch pad, after which indicator will blink.
indicator turns yellowish
SOUND
mode, where low bass and
button on the main unit or
SOUND
SOUND
pad for more than
SOUND
DK-AP8P
ENGLISH
E-8