Remote control
DK-AP8P
■ Batteries installation
ENGLISH
1
Whilst pushing the locking tab towards the centre of the
remote control, slide out the battery holder.
Back of remote control
2
Remove the old batteries from the battery holder, insert
two new batteries and then slide the battery holder back
into the remote control.
Battery holder
Polarity (+) symbol
Battery type
Locking tab
Precautions for battery use:
●
Remove the batteries if the unit will not be used for a long
period of time. This will prevent potential damage due to
battery leakage.
Caution:
●
Do not use rechargeable batteries (nickel-cadmium battery,
etc.).
●
Danger of explosion if battery is incorrectly replaced.
●
Replace only with the same or equivalent type.
●
Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
●
Installing the batteries incorrectly may cause the unit to
E-7
malfunction.
Locking tab
Positive (+)
side up
Notes concerning use:
●
Replace the batteries if the operating distance is reduced or
if the operation becomes erratic. Purchase 2X "CR 2032",
coin lithium battery.
●
Periodically clean the transmitter on the remote control and
the sensor on the unit with a soft cloth.
●
Exposing the sensor on the unit to strong light may interfere
with operation. Change the lighting or the direction of the unit
if this occurs.
●
Keep the remote control away from moisture, heat, shock,
vibrations and any conductive materials to avoid malfunction.
■ Test of the remote control
Point the remote control directly at the remote sensor on the unit.
The remote control can be used within the range shown
below:
Remote sensor
ON/STAND-BY
15˚ 15˚
MENU
ON/STAND-BY
E
SOUND
0.2 m - 6 m
(8" - 20')
TV DISPLAY
SHUFFLE
ENTER
E
SOUND