Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
C o n n e c t i o n s a n d S y s t e m
Settings
Connecting the Plasma Display to a
Computer
Consult the section "Installation and Connections"
of the plasma display's Operating Instructions for
details on connections to a computer.
Adjusting the Plasma Display
Turn on power to plasma display and computer. Look
at the plasma display's Operating Instruction items
for "System Settings" and "PICTURE/SCREEN
Adjustment".
7 First, set the "System Settings".
Set "SIGNAL FORMAT".
To use 1280 x 768 (60 Hz/70 Hz) screen
resolution and refresh rate, set "SIGNAL
FORMAT" to "WXGA."
With the screen image turned on, select MENU
= SETUP = SIGNAL FORMAT = SET, and
change the XGA setting to WXGA.
Example of menu displayed on the PDP-
504CMX/PDP-50MXE1
MENU
PICTURE
SCREEN
POWER MANAGEMENT
CLAMP POSITION
SIGNAL FORMAT
INPUT1
SETUP
OPTION
:
OFF
:
AUTO
:
:
XGA
7 Next, adjust "SCREEN" to set the image
position and clock.
÷ Confirm that "MASK CONTROL" and "ORBITER"
are set to "OFF". Consult the plasma display's
Operating Instructions for details on how to con-
firm these settings.
÷ Confirm that the "ENERGY SAVE" item is set to
"STANDARD".
÷ The proper screen settings cannot be made if
"POINT ZOOM" is used to enlarge part of the
screen, or if SPLIT button is used to divide the
screen into multiple smaller screens.
÷ If "AUTO SET UP MODE" is set to "ACTIVE", the
displayed screen may require recalibration.
Installing the Driver Software
Consult the Driver Installation Guide for the driver
software (provided with this unit).
INSTALLATION
21
En
Werbung
Kapitel
Inhaltsverzeichnis
