Parkside PDAP 75 A1 Originalbetriebsanleitung Seite 20

♦ Use the pressure reducer on the compressed air source to set
the optimum working pressure. Note that the maximum working
pressure may not be exceeded. An excessive working pressure
does not mean increased output; it merely increases the air con-
sumption and accelerates appliance wear. Always comply with
the technical information.
NOTE
► Do not apply the polish too often to the same surface as the
particles it contains could damage the finish.
► Mask any plastic components beforehand as these could be
brightened by the polish.
♦ Switch the compressed air polisher on.
♦ Guide the compressed air polisher parallel onto the workpiece.
♦ Move the appliance parallel to and evenly over the surface being
polished.
♦ Do not press down on the compressed air polisher. Pressing
down hard does not increase the working efficiency!
♦ When you are satisfied with the result, release the trigger
switch off the appliance.
♦ When you have finished working, disconnect the appliance from
the compressed air source.
CAUTION!
► Depending on the size and nature of the workpiece, suitable
safety precautions must be taken. Use suitable clamps to pre-
vent the workpiece from slipping.
► In the event of an interruption to the air supply, release the
trigger immediately.
PDAP 75 A1
GB │ IE │ NI │
to
17 ■