Westfalia WT 487 Bedienungsanleitung Seite 13

Lift up the mobile device from
the charging surface and put it
back on properly.
Light is flashing when not
charging properly due to a
general error.
Do not place foreign materials,
such as metal objects, magnets
and magnetic stripe cards,
between the mobile device and
the wireless charging target
circle during charging.
CAUTION: -
1. Do not place a wireless charging receiver solely on the wireless charging surface.
Doing so may overheat the wireless charger and cause a fire. It may also result in
serious burn or device malfunction.
2. If you place a mobile device on the wireless charging surface for an extended period,
the wireless charger may overheat and stop charging.
3. Do not cover or block the heat release vent at the back of the clock radio.
4. When the mobile device is fully charged, remove it from the wireless charging surface.
5. Do not place foreign materials, such as metal objects, magnets, magnetic stripe cards,
paper clips etc. between the mobile device and the wireless charging surface. The
mobile device may not charge properly or may be damaged due to overheating.
6. Wireless charging may not work properly if you attach a thick case to your mobile
device. If your case is thick, remove it before placing your mobile device on the wireless
charging surface.
7. If you connect a charger to the mobile device during wireless charging, the wireless
charging feature will be unavailable.
TO CHARGE MOBILE DEVICES WITH THE USB PORT
Connect the charging cable of your mobile phone to the A-type USB port at the back of the unit, then
connect the other end to your mobile phone. The clock radio will charge the mobile phone
automatically.
Notes :
1. Make sure to use the original cable of your mobile phone for charging
2. Make sure the original adaptor (5V-2.5A) enclosed with your clock radio is being used
to power your clock radio. Using other adaptors may not charge your phone.
3. iPad and Notepad charging is not applicable.
4. Charging one mobile device by the USB port and another mobile device by the wireless
charger at the same time will reduce the charging efficiency and extend the charging
time.
Do not place any foreign object
(metal) on the charging coil at any
time or under the mobile device
EN4
during charging