AEG Voxtel R200 Schnellstartanleitung Seite 10

10
4.8
In VOX mode, the unit will transmit a signal only when it is activated by
your voice or other sounds around you. The unit will transmit further
for 2 seconds even if you stop talking.
The level of VOX sensitivity is shown by a number on the LCD screen.
At the highest level, the units will pickup softer noise (including
background noise); at the lowest level, it will pick up only louder noise.
• Press the menu button
"OF" flashes on the LCD screen.
• Press the up button
(the maximum level is 3.)
• To deactivate the VOX function, press the down button
appears on the LCD screen.
• Press the PTT button to confirm your setting.
appear on the LCD screen as along as the VOX feature is activated.
Note:
VOX operation is not recommended if the unit will be used in a noisy
or windy environment.
4.9
Channel scan perform searches for active signals in an endless loop for
all 8 channels, 38 CTCSS codes and all 83 DCS codes.
• Press the menu button
screen.
• Press the up
an active signal is detected, channel scan pauses on the active
channel.
• Press the menu button
screen press the up
CTCSS from 1-38.
• Press the menu button
screen. Press the up
code 1-83.
• Press the PTT button to confirm your setting.
AEG R200_V1.indd 10
Setting the VOX (voice activated) sensitivity
4 times,
to set the VOX sensitivity into maximum level
Activating the auto channel scan
or down
or down
or down
VOX
icon will be displayed and
SC
5 times, icon will display on LCD
button to begin scanning channels when
six times, CTCSS flashes on the LCD
button to begin scanning the
seven times, DCS flashes on the LCD
button to begin scanning DCS
until "OF"
VOX
will steady
29/06/2012 21:43:32