Installing A Cartridge - Yamaha GT-5000 Bedienungsanleitung

„ Installing a cartridge
A cartridge is not included with this product. Follow the
steps below to install a commercially-available cartridge
into the head shell.
Note
Refer to the instruction manual for the cartridge.
1
Connect the lead wires to the cartridge
Lead wire
Red
Green
White
Blue
2
Provisionally secure the cartridge to
the head shell
3
Adjust the position of the cartridge
Adjust the position of the cartridge and stylus as
shown in the following illustration.
52 mm
Note
The overhang of the tonearm on this unit is
−17 mm.
4
Firmly secure the cartridge
Verify that the side of the head shell is parallel
with the cartridge, and then firmly tighten the
screws.
16
Connector
R+ (red)
Æ
R– (green)
Æ
L+ (white)
Æ
L– (blue)
Æ
5
Attach the head shell to the tonearm
Insert the head shell into the front end of the
tonearm, and turn the lock nut to secure it.
Note
If you prefer, attach the washer to the head shell.
Washer