Silvercrest HG03107 Montage-, Bedienungs- Und Sicherheitshinweise Seite 31

To avoid damaging the cord, do not squeeze,
bend or chafe it on sharp edges . Keep it
away from hot surfaces and open flames as
well .
Lay out the cord in such a way that no
unintentional pulling or tripping over is
possible . Keep the power adaptor and its cord
out of reach of children .
Do not use the power adaptor with wet hands .
Do not touch the power adaptor with wet
hands .
WARNING! Do not open the power
m
adaptor casing under any circumstances . Do
not insert any objects into the inside of the
casing .
Do not pull the power adaptor out of the
electrical outlet by the connection cord and
do not wrap the connection cord around
the product . Connect the power adaptor to
an easily reachable electrical outlet so that
in case of an emergency the product can
be unplugged immediately . Pull the power
adaptor out of the power supply to completely
switch off the product .
The power adaptor continues to draw a
small amount of electricity, even without the
camera being operated, as long as the power
adaptor is connected to the mains network .
To completely switch off the power adaptor, it
must be disconnected from the mains network .
Do not hang any objects on the product, even
if it is only decoration .
Disconnect the power adaptor from the power
supply when not in use and before cleaning .
Do not drop the product or subject it to
physical shock .
If smoke or unusual sounds are observed,
immediately unplug the power adaptor from
the power supply . Have the product and the
power adaptor checked by a specialist before
using it again .
The power adaptor shall not be covered .
The power adaptor shall not be exposed to
dripping or splashing water .
Cables have to be laid securely .
Do not aim the camera directly into the sun or
at other intense light sources that could affect
the image quality, and also shorten the service
life of the image sensor .
WARNING! Do not install the product
m
near flammable gases or potentially
explosives areas (e.g. paint shops)
with the wireless transmitter on, as
the radio waves emitted could cause
explosions and fire.
If you have any doubt about installation/use
of this product, consult a qualified person .
Make sure that the location planned for the
camera is well ventilated .
DANGER! Radio interference!
m
Switch the product off on aeroplanes, in
hospitals, service rooms, or near medical
electronic systems . The wireless signals
transmitted could impact the functionality of
sensitive electronics .
Keep the product at least 20 cm from
pacemakers or implantable cardioverter
defibrillators, as the electromagnetic radiation
may impair the functionality of pacemakers .
The radio waves transmitted could cause
interference in hearing aids .
Do not place the product near flammable
gases or potentially explosives areas
(e .g . paint shops) with the wireless
components on, as the radio waves emitted
can cause explosions and fire .
The range of the radio waves varies by
environmental conditions . When using the
wireless data transmission, unauthorised third
parties receiving the data cannot be excluded .
GB/IE 31