Infrared Remote Control Unit - Sony NSR-S10 Installationsanleitung

D I/O Port
Use this connector to connect audio,
sensor inputs, and relay outputs.
For connection details and wiring
diagrams for sensor inputs, see "I/O
Port" (page 21).
E e-SATA connector
Use this connector to connect storage
devices that support the e-SATA
interface.
F
LAN connectors (1, 2)
Use these connectors to connect 10
Base-T, 100 Base-TX, or 1000 Base-T
network cables.
The top connector is LAN2, and the
bottom connector is LAN1.
LAN1: Network camera
LAN2: Network camera (LAN2 can
only be used when using a different
segment from LAN1.)
CAUTION for LAN ports
For safety reason, do not connect the
LAN ports to any network devices that
might have excessive voltage.
Follow the instructions for the above
ports.
G 1 Power switch
Press this to turn on the unit.
Note
Although this button can be used to
force a shut off of power to the unit,
under normal circumstances the
shutdown command on the screen
should be used.
H DC IN connector (12 V)
Use this connector to connect the AC
adapter.
12 Features and Functions
I Cable clamp hole
Attach the supplied cable clamp here to
prevent the power cord from
disconnecting.
Infrared remote control
unit
If a button on the infrared remote control
unit is pressed while the remote control unit
is pointed at the infrared sensor on the main
unit, then the main unit will perform the
operation corresponding to that button.
A Play button
Use this button to play recorded images.
m (Fast Rewind) button
Use this button for fast rewind. (2x, 4x,
8x, 16x, 32x, 64x speed)
n (Reverse Play) button
Use this button to play recorded images
in reverse.