Medion NAS 3 TB Bedienungsanleitung Seite 275

Network
Primary DNS Server
Enter the primary DNS server IP address here.
Secondary DNS Server
Enter the secondary DNS server IP address here.
20.1.3. HTTP (Web Configurator)
Enable Secondary HTTP Port
Here you can configure an additional HTTP port that can be used to access
the Web configurator.
Enter a number in the port number field.
Jumbo Frames
Jumbo Frames improve network performance. Jumbo Frames require a 1
Gbps (Gigabit Ethernet) network that must also support Jumbo Frames.
Set the largest possible frame size that is supported by all network devices
(network cards in computers as well as switches, hubs and routers).
When the Jumbo Frames function is activated, you can choose between a 4
KB, 8 KB and 9 KB frame size.
PLEASE NOTE!
If you activate the Jumbo Frames function on an NAS server in
a network that does not support this, you will lose access to the
NAS server. If this occurs, you will have to reset the NAS server to
the factory settings.
Network Diagnostic Tool
Use this function to test the network connection to a specific IP address
or domain. Select an address or enter one in the entry field. Then click on
"Ping" to send a packet from the NAS server to the network connection.
Successfully pinged host – The NAS server was able to "ping"
•
the NAS server, the network connection is available.
Unable to ping host– The NAS server was unable to "ping" the
•
host, the host could not be found.
274 of 344