Hama AV-1200 AIR Bedienungsanleitung Seite 28

Transmitter Introduction
Front, Side & Back Panel
1. 2.4GHz LED
2. IR Sensor
3. Source LED
4. VCR Source Key
5. TV1 Source Key
6. UHF Antenna
7. VCR Input/Output Port
8. SAT Input Port
9. 2.4GHz Integrated Antenna
10. Audio Stereo Output Port
11. IR Transmitter Port
12. TV1 Input/Output Port
13. AV Input Port
14. DVD Input Port
15. Power Input Port
Shows ON/OFF status of the 2.4GHz RF transmission function.
Receiving IR signal from the remote controller.
Source indicator.
Press this key to change between input sources on VCR.
Press this key to turn on the 2.4GHz RF transmission function
When the included power adaptor is connected, press this button
to switch between input sources on TV1.
When the 2.4GHz LED is lighting, hold this key for 3~5 seconds to
shut down the 2.4GHz RF transmission.
This allows the input/output of COMPOSITE signals.
It is recommended to connect VCR-type devices to this port.
This allows simultaneous input of COMPOSITE and RGB signals.
It is recommended to connect IRD-type devices to this port.
Stereo audio output. Same with TV1's sound output.
Connect the included IR transmitter to this port.
This allows the IR transmitter to control all devices that are
connected to the transmitter unit via IR sensor and
433 MHz frequency.
Note: Make sure the IR transmitter is facing the IR sensor
of all signal sources.
This allows simultaneous COMPOSITE or RGB signal output
and COMPOSITE signal input.
This allows COMPOSITE signal input.
This allows simultaneous input from COMPOSITE or RGB signals.
It is recommended to connect DVD-type devices to this port.
Connect the included power adaptor to this port.
– 28 –