Safety Instructions - Klarstein Herakles Bedienungsanleitung

EN
10

SAFETY INSTRUCTIONS

• The machine has safety protection device. The electrical machine does not work
when fastener does not closely fasten top cover or knife stand is not screwed tightly
to ensure safety use.
• Please check if power supply is in line with rated voltage before use to avoid
damage.
• Clean all dismountable parts.
• Please read carefully „Product Desciption" and „Assembling" picture for
assembling.
• Please read carefully all instructions before use.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.
• Care is needed when handling cutting blades, especially when removing the blade
from the bowl, emptying the bowl and during cleaning.
• This machine is unavailble for the weakness, unresponsive or psychopathic
perosn(including children), unless under the direction or help from the person
who have the responsibility for security. Children should be overseen, so it can be
testified that they are not playing with it.
• Put the machine in the stable surface and operate as per the above procedure.
• Do not wash main motor and power plug with water or other liquid. Only wipe
them with damp cloth.
• Don't remove the cup lid during operation. Don't put the hand or other vessel
into blender cup and feeding hole when power is still on. Otherwise accident or
damage will happen.
• This product must not be idle nor exceed the requirement in processed amount
(normally, less than 60 percent would be best). Otherwise, bearings of motor and
blade will overheat.
• Blades are very sharp. In order to avoid injury, when washing blades, please put
them under water tap to wash. Do not wash them with hand.
• Please don't leave when the machine is working. Don't let children operate the
machine.
• Remove power plug and then pour out the food after every operation.
• Do not put any parts into high temperature sterilizer to sterilize or boiler to steam
and boil for sterilization.
• The machine is not recommended for other usage.
• In order to prolong useful life of the machine, there is overheat protecting unit on
motor. When motor runs too long or with too heavy load, the temperature reaches
warning value, motor will stop automatically. After motor stops, pull out power
supply plug. Wait for motor to cool (about 20 to 30 minutes), then use again.
• If power supply flexible cord is damaged, to avoid danger, do ask factory, its
service department or other special person to replace.
• If any problem with this machine, do not disassemble by yourself, contact the
service department.