Filling In The Water Tank; Steam Ironing - Grundig SIS 9450 Bedienungsanleitung

OPERATION ______________________________
8 L et the appliance cool down in a location that
is safely out of reach of children.
Filling in the water tank
1
G rab the handle
G
out of the steam iron.
2
O pen the lid of the water filling opening
and fill the water tank
tilled water up to the MAX marking. The maxi-
mum capacity is 1.7 litres.
3 C lose the lid of the water filling opening
and push the water tank
steam iron station
C
into place properly and is secured to the hous-
ing of the steam iron station
Caution
Do not move or shake the steam iron station
7
when the water tank
might spill out from the opening of the water
tank .
J
4 P ress the steam button
iron. After about 2-3 minutes the iron will be
ready for steam ironing.
Notes
When the water tank
7
into the pump causing a louder 'pumping'
sound. This is quite normal.
If your tap water is very hard it is recom-
7
mended to mix the tap water with distilled
water on a 50:50 ratio.
Steam ironing
1
P lace the appliance on an even, dry and non-
slip surface. The non-slip feet
stability of the appliance.
2 F ill the water tank
N
tion "Filling in the water tank".
3 I nsert the power plug
4
P ush the On/Off switch
steam iron station
C
– The power indicator
steam indicator light blinks on LOW
and pull the water tank
with tap water or dis-
N
completely into the
N
. Make sure that it clicks
.
C
is being filled. Water
N
briefly to reset the
I
is empty, air enters
N
ensure the
W
as described in the sec-
B into the wall socket.
to switch on the
U
.
O lights up and the
T .
5
A djust the temperature control dial
desired temperature.
– The temperature indicator light
up blue. The temperature indicator light
remains on while the iron is heating up. As
N
soon as the iron reaches the set temperature,
the temperature indicator light
The temperature indicator light
J
and off during usage to indicate that the set
temperature is being regulated.
Note
Steam ironing is only possible at higher tem-
J
7
perature settings marked with
6 T he water in the water tank
2-3 minutes. As soon as the temperature indica-
tor light
E
the steam setting remains lit, the steam iron is
ready to use. Place the iron in horizontal posi-
C
tion on the garments and press the steam but-
ton I . Continue to move the iron when ironing.
Caution
Never direct the steam at people or pets.
7
Notes
When the steam iron station
7
will produce a 'pumping' sound. This is normal
and indicates that water is being pumped from
the water tank
7
S elect a higher steam level with the steam but-
tons "+" or "-".
– The corresponding control indicator blinks
as soon as it is selected. After approx. 2-3
minutes the control indicator will remain lit,
indicating that the appliance is ready for

steam ironing.

8 W hen there is insufficient water left in the water
tank the steam generation stops and the
N
water filling indicator
an audible beep. The control indicator in the
selected steam setting goes off. Place the iron
onto the storage base
tank (see section "Filling in the water tank").
N
9
A fter iron process is complete, place the iron
onto the storage base
.
heats up within
N
goes off and the control indicator in
is switched on it
C
into the steam iron station
N
lights up, followed by
Q
and refill the water
L
.
L
ENGLISH
to the
K
E lights
E
goes off.
E
will go on
E
.
C
25