Security Instructions - Klarstein Baristomat 10033138 Bedienungsanleitung

EN

SECURITY INSTRUCTIONS

Before using the device, basic precautions should always be taken including the
following to protect against damage to the device, fire, electric shock and injury to
persons or property:
Read this booklet thoroughly and save it for future reference.
This device is designated for preparing hot beverages using water and milk and to be
used in indoors household environments, only, holding a grounded power supply for
the device and a plane, dry, hazard free, heat-resistant, food-safe working surface the
device can be placed on and safely operated at.
The device is not designed for continuous operation.
This device may be used by persons, including children aged 8 and above, with
reduced physical, sensory or mental capabilities or lack of knowledge or experience, if
they are authorised to use this device or have been instructed by an authorised person
how to use the device in a safe way and have understood the hazards involved with the
use of the device before using this device. An authorised person is a person, who has
read and understood this manual and is able to use this device in a safe way including
the hazards involved.
Do not use the device for other than its designated use to ensure proper functioning.
Do not allow children to play with the device. The device si hot during operation and
may cause severe injuries from burns.
Do not use or operate this device if damaged in any way or malfunctioning, but leave
it disconnected from the power outlet and contact a service centre authorised by the
manufacturer for examination, repair or electrical or mechanical adjustment. Do not
modify the device and do not attempt to repair the defective device yourself.
Please, only use accessories recommended by the manufacturer of this device to prevent
danger from physical damage, fire or electric shock to the device or injury to persons.
Make sure that the device is properly connected to a working water supply or that
the fluid tank(s) of the device is always filled with the amount of fluid needed for the
intended operation, respectively, to prevent damage to the device.
24