General Guidelines; Installation - Velleman EXCITER 250 Bedienungsanleitung

• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
• Caution ! Never look directly into the light source, as sensitive persons may suffer an epileptic shock.
• Please be aware that damages caused by manual modifications to the device are not subject to warranty.
• Keep away from children and non-professionals.

3. General Guidelines

• This device is a lighting effect for professional use on stages, in discotheques, theatres, etc. This fixture is only
allowed to be operated with and alternating current of max. 230VAC/50Hz and was designed for indoor use only.
• Lighting effects are not designed for permanent operation. Consistent operation breaks will ensure that the device
will serve you for a long time without defects.
• Do not shake the device. Avoid brute force when installing or operating the device.
• When choosing the installation spot, please make sure that the device is not exposed to extreme heat, moisture
or dust. The minimum distance between light-output from the fixture and the illuminated surface must be more
than 0.5 meter.
• Always fix the fixture with an appropriate safety cable (VDLSC7 or VDLSC8).
• Make sure never to install the device in a place that exceeds the ambient temperature T
specifications at the end of this user manual).
• Operate the device only after having familiarized yourself with its functions. Do not permit operation by persons
not qualified for operating the device. Most damages are the result of unprofessional operation.
• Please use the original packaging if the device is to be transported.
• For safety reasons, please be aware that all modifications on the device are forbidden. Furthermore, any other
operation may lead to short-circuit, burns, electric shock, lamp explosion, crash, etc. If this device will be operated
in any way different to the one described in this manual, the product may suffer damages and the guarantee
becomes void.

4. Installation

a) Lamp
• Only fit or replace a lamp when the device is unplugged from the mains.
• The lamp has to be replaced when it is damaged or deformed.
• Let a lamp cool down before replacing it as the temperature of a lamp can reach 700°C during operation. Also, do
not switch the lamp back on within 10 minutes after having turned it off.
• Do not touch the lamp with your bare hands. Use a cloth to insert or remove it.
• Do not install lamps with a higher wattage than what this device was designed for.
• For the installation, you need a 90V / 250W MSD GY9.5 lamp:
order code : LAMP250MSD or LAMP250MSD/2
1) Unscrew the 2 screws marked with X and Y on the back of the housing, holding the plate where the lamp is
underneath.
2) Carefully insert the lamp into the socket. Please remember there is only one way to insert the lamp. Gently
slide the lamp and its lamp holder back into place and fasten the 2 screws.
3) On the access plate there are 3 small screws marked A, B and C which are used to adjust the lamp holder in
the lamp housing. You can adjust the 3 screws to fine-tune the position of the lamp to get the maximum light
output.
• Please remember the lamp is not a hot-restrike type, you must wait for approximately 10 minutes after having
turned off the lamp before you can turn it back on again.
Remark: Do not operate the device when the glass pane is off.
VDP250SC6M
2
(see technical
a
VELLEMAN