Calibrating The E-Scooter; Cleaning The E-Scooter; Error Messages; Risk Of Injury - Medion S89047 Bedienungsanleitung

8. Calibrating the E-Scooter

You must calibrate the E-Scooter if the LED balance sensor starts shining red, or if
the E-Scooter runs unevenly, vibrates or pulls to one side.
 Place the device on an even surface, with both wheels pointing forward and
straighten the footboard. Use a spirit level to get the best result.
 Press and hold down the on/off switch on the rear of the device for a few
seconds until you hear a number of signal tones.
 Then press the on/off switch again to switch the device off and then on again.
You have now calibrated the E-Scooter.

9. Cleaning the E-Scooter

 Remove the battery charger before cleaning the E-Scooter.
 Use a soft, damp cloth to clean the device.
 Do not use chemical solutions or cleaning agents because these may damage
the device's surface or the labels on it.
 Use water and a soft brush to clean any stubborn dirt from the wheels. Take care
to ensure that no liquid/water gets into the interior of the device.

10. Error messages

The E-Scooter is equipped with a number of different safety features.
WARNING!

Risk of injury!

Ignoring error messages can result in injuries.
 Stop the device and get off immediately if you hear
or see an error message. Then check the device.
Error messages are displayed when:
• Surfaces are unsafe (uneven, too steep).
• The battery charge is too low.
• The maximum speed has been reached or speed is too high.
• The motor overheats.
• The pitch angle of the footboards is more than 17 °, when you are getting on or
travelling.
• The balance sensor fails.
• The E-Scooter has been shaken for more than 30 seconds.
88