Device Overview; Preparations For Use; Charge The E-Scooter Battery - Medion S89047 Bedienungsanleitung

5. Device Overview

1) Wheelhouse
2) Footboard
3) Battery charge display
4) LED balance sensor
5) Tyres
6) LED battery display
7) Housing
8) Charging connector (on reverse side)
9) On/Off switch (on reverse side)

6. Preparations for Use

 Remove all packaging materials.

6.1. Charge the E-Scooter battery

The battery charge display in the centre of the E-Scooter shows the battery charge
level:
If the LED is shining blue:
If the LED lights is shining
red/you hear a signal
tone:
The E-Scooter is switched off.
 Make sure the charging connector is clean.
 Connect the charging cable, with the 3-pin plug on it, to the charging connector
on the rear of the E-Scooter.
 Connect the battery charger to a power supply.
The LED flashes orange when the battery is charging.
84
1 2
5 6 9
battery is more than 50% charged.
battery has less than 20% charge, and must be
charged.
 Stop using the E-Scooter if the LED lights up.
3 2
4
8 7 6
1
5