Optional Accessories; Maintenance - Makita RT0700C Bedienungsanleitung

For the plunge base (optional accessory)
1
1. Dust nozzle
2. Thumb screw
011853
Use the dust nozzle for dust extraction. Install the dust
nozzle on the tool base using the thumb screw so that
protrusion on the dust nozzle fit to the notch in the tool
base.
Then connect a vacuum cleaner to the dust nozzle.
Fig.45

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Replacing carbon brushes
Fig.46
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Fig.47
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
2

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Straight & groove forming bits
•
Edge forming bits
•
Laminate trimming bits
•
Straight guide assembly
•
Trimmer guide assembly
•
Trimmer base assembly
•
Tilt base assembly
•
Plunge base assembly
•
Offset base assembly
•
Templet guide
•
Collet cone 6 mm
•
Collet cone 6.35 mm (1/4")
•
Collet cone 8 mm
•
Collet cone 9.53 mm (3/8")
•
Wrench 13
•
Wrench 22
•
Trimmer bits
Straight bit
Fig.48
D
20 6
20E 1/4"
8
8
8 6
8E 1/4"
6 6
6E 1/4"
011929
"U"Grooving bit
Fig.49
D
6 6
6E 1/4"
006486
"V"Grooving bit
Fig.50
D A
1/4"
20
006454
14
or attachments
Only use accessory or
A L 1
20 50
60
8
50
6
50
A L 1 L 2
6 60 28
mm
L 1 L 2
50 15 90
are
mm
L 2
15
25
18
18
mm
R
3