Changing The Settings Via The Base Station; Menu Structure; Phone Numbers Menu; Accessories Menu - Medion P89400 Bedienungsanleitung

Changing the settings via the base station

The base station is equipped with an LCD display which you can use to navi-
gate through the menus and set up your alarm system.
− In order to open the menu, enter your admin code on the base station
and press Enter (default admin code: 123456)
− Use the "↑" and "↓" buttons to navigate to the desired setting and open
the menu or submenu by pressing "Enter".
Using the keypad
"*" = delete
"↓" = forward
"↑" = back
"Enter" = select/confirm
"Esc" = back/previous step in menu/cancel
All of the settings that can be changed via the base station will be summa-
rised in the tables on the next few pages.

Menu structure

Phone numbers menu

− Select the SMS number or phone number to be edited, enter the phone
number and confi rm with the "Enter" button.
• You can delete characters using the "*" button.
• 5 phone numbers and 5 SMS numbers can be saved to the base station.

Accessories menu

This menu can be used to add or delete the remote control, RFID tags and
wireless sensors as accessories. Also see "Troubleshooting" on page 108.
Test mode
You can test the sensors here that you previously connected to the base station.
You will hear 1 beep and the display will show the signal that is being sent
from the sensor triggered in each individual case. Ensure that all of the sen-
sors that you trigger are shown on the display.
− Press "Esc" to end the test mode.
94 of 168