ABB CM-HC Montageanleitung Seite 2

Installation instructions
CM-HC Suspension electrode
CM-HCT Suspension electrode, suitable for drinking water
Must be installed by technically qualified persons only.
Further information and data is obtainable from the catalogues and data sheets of this product, from the local ABB sales organisations
as well as on the ABB homepage www.abb.com. Subject to change without prior notice. The German text applies in cases of doubt.
Fig. 1
Fig. 2
Fig. 3
The appropriate connecting cable depends on the used medium and on the national standards!
Fig.1
Place the locking cap, the cutting ring and the o-ring in the illustrated order on the connecting cable. Insulate the end of the cable
11 mm (0.433 in).
Fig. 2
Push the ferrule firmly onto the copper cable, so that the copper wire protrudes out of the ferrule. Crimp the thin end of the ferrule with a
suitable tool to achieve a solid connection between ferrule and copper wire. Cut the excess cable flush with the ferrule. Put the pressure
spring on the ferrule and push it into the electrode. Move the o-ring and the cutting ring close to the ferrule.
Fig. 3
Screw the locking cap and the electrode together, handtight or with a tightening torque of 1.2 Nm. Then screw the protective cover on
the locking cap.
Dipped electrode
CM-HC: high-alloy steel, material no. 1.4104 (according to EN 10088-1)
CM-HCT: high-alloy steel, material no. 1.4301 (according to EN 10088-1)
locking cap cutting ring
pressure spring
ferrule
O-ring
11 mm
electrode
protective cover
English
Art.-No. 1SVR 402 902 R1000
Art.-No. 1SVR 402 902 R2000
2