Programming The Overload Warning Value - Silvercrest Z30412 Bedienungsanleitung Und Sicherheitshinweise

66149_silv_Energiekosten-Messgerät_Content_GB-FI-SE-DE.indd 35 25.05.11 15:06
the time at which the maximum power
consumption was measured, along
with the power factor in cos phi.
Note: The maximum power consump-
tion is stored until a higher value is
measured. Only then is the older value
overwritten in the meter's memory.
Press and hold down the FUNCTION
button 2
erase the stored values.
©
Programming the
overload warning value
Note: In addition to a maximum value
for the power consumption (W), you can
program a maximum value for the current
(A). Here again, the energy cost meter
carries out further measurements if the
maximum value is exceeded.
for approx. 3 seconds to
GB/IE 35