Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installing the Auxiliary Handle (Fig. 5)
Install the auxiliary handle (1) for two handed operation of the drill. This is particularly important for drilling in concrete.
• Rotate the auxiliary handle counter clockwise to open mounting collar (2).
• Slide the auxiliary handle collar over the chuck and fully onto the drill housing (3).
• Rotate the auxiliary handle to a comfortable position.
• Rotate the auxiliary handle clockwise to tighten the mounting collar onto the drill housing.
• NOTE: Do not over tighten the auxiliary handle. You will break the mounting collar.
Fig. 5
Installing the Depth Rod (Fig. 6)
• The depth rod is used as a gauge to control the depth of the drilled hole.
• Rotate the auxiliary handle (1) counter clockwise to open the mounting collar.
• Insert the hexagonal depth rod (2) into the matching hole in the auxiliary handle mounting collar (3).
• Position the depth rod so the tip (4) will contact the workpiece when the drill reaches the appropriate depth.
• NOTE: The auxiliary handle must be placed in the horizontal position to allow depth rod to be inserted into the mounting
collar. Tighten the auxiliary handle by rotating it clockwise.
Drilling (Fig 7.)
• When drilling into smooth, hard surfaces such as metal, use a centre punch to mark the desired hole location. This will prevent
the drill bit from slipping off centre as the hole is started.
• The workpiece to be drilled should be secured in a vice or with clamps to keep it from turning as the drill bit rotates
• Check the drill bit to make sure it is firmly locked into the drill chuck, and verify that the forward/reverse switch is in the
forward position.
• Hold the drill firmly with both hands whenever possible. Use one hand to grasp the handle and switch.
• NOTE: Make sure the hand placed on the body of the drill does not cover the air vents. Covering these air vents will reduce
motor cooling, and possibly lead to overheating the motor.
• While holding the drill firmly, place the point of the drill bit at the point to be drilled. Squeeze the switch trigger to start the
drill.
• Move the drill bit into the workpiece applying only enough pressure to keep the bit cutting. Do not force the drill bit or apply
sideways pressure to elongate the hole.
Fig. 6
Werbung
