Specifications; Additional Safety Rules - Makita 4403 Betriebsanleitung

ENGLISH
1. Switch lever
2. Wrench 10
3. Wrench 17
4. Tighten
5. Loosen
6. Knob
7. Thumb screw
8. Crank handle
9. Chip guard

SPECIFICATIONS

Collet chuck capacity
No load speed (min
Max. width of work
Max. width of work (45°)
Max. height of work
Transverse travel of table (bed)
Longitudinal travel of table (bed)
Overall dimensions (L x W x H)
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the tool. Be sure
that you understand their meaning before use.
............ Read instruction manual.
............. DOUBLE INSULATION
Intended use
The tool is intended for use in working aluminum sashes.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
4
Explanation of general view
10. Workpiece
11. Transverse feed handle
12. Longitudinal feed handle
13. Table
14. Vise
15. Crank handle
16. Wing nut
17. Angle gauge
18. Screw (A)
Model
-1
)
Net weight
Safety class
19. Screw (B) (2 pcs.)
20. Brake screw
21. Trimmer base assembly (optional
accessory)
22. Motor
23. Trimmer
24. Limit mark
25. Brush holder cap
26. Screwdriver
6 mm (1/4")
123 mm
185 mm
113 mm
327 mm x 350 mm x 355 mm

ADDITIONAL SAFETY RULES

1. Hold tool by insulated gripping surfaces when per-
forming an operation where the cutting tool may
contact hidden wiring or its own cord. Contact with
a "live" wire will make exposed metal parts of the tool
"live" and shock the operator.
2. Wear hearing protection during extended period of
operation.
3. Handle the bits very carefully.
4. Check the bit carefully for cracks or damage
before operation. Replace cracked or damaged bit
immediately.
5. Avoid cutting nails. Inspect for and remove all
nails from the workpiece before operation.
6. Hold the tool firmly.
7. Keep hands away from rotating parts.
8. Make sure the bit is not contacting the workpiece
before the switch is turned on.
9. Before using the tool on an actual workpiece, let it
run for a while. Watch for vibration or wobbling
that could indicate improperly installed bit.
10. Be careful of the bit rotating direction and the feed
direction.
11. Do not leave the tool running. Operate the tool
only when hand-held.
4403
30,000
77 mm
73 mm
16 kg
/II