Material Damage; Before Using For The First Time - Silvercrest SCM 1500 A1 Bedienungsanleitung

RP100103 Crepes-Maker LB6so Seite 7 Freitag, 9. Mai 2014 2:06 14

4.8 Material damage

Caution! To avoid material damage,
please observe the following conditions.
• The appliance must not be placed on
hot stoves, put in a hot oven or set up in
the vicinity of gas heaters and on-
demand water heaters, as this could
cause damage.
• Only use implements made from wood
or heat-resistant
During manufacture, many parts are given a
thin film of oil to protect them. Before using
the appliance for the first time, run it without
crêpes to allow any residues to evaporate.
Note: When heating up for the first few
time a slight smell may be produced. Make
sure the room is adequately ventilated.
1. Take the appliance out of the pack-
aging.
2. Check that the appliance shows no signs
of damage.
3. Clean the appliance before using it for
the first time. Observe the information in
the section entitled "7. Cleaning and
storage" on page 9.
4. Select a location that is firm, level and
not flammable. Maintain a distance of
approx. 50 cm from other objects.
5. Unwind the mains cable completely.
6. Place the baking plate 1 on the bottom
section 2.
SCM 1500 A1
• Surface cleaners (furniture and work
• Do not place any items on the
• If the appliance is connected to the
plastic. Metal

5. Before using for the first time

7. Insert the power supply plug into a suita-
8. Turn the temperature control to "MAX".
9. Leave the appliance switched on for
10. Remove the power supply plug and allow
11. Clean the appliance again. Take note of
Note: The first crêpes you make should be
thrown away, not eaten, as they will not taste
right.
implements may damage the coated
surfaces.
surfaces) may contain ingredients that
could attack and soften the rubber feet.
In this case, place the appliance on a
non-flammable surface.
appliance.
mains it may be damaged by lightning
during thunderstorms.
ble mains socket.
The red indicator 3 comes on to show
that the appliance is connected to the
power supply.
As soon as operating temperature has
been reached, the green indicator 5
comes on.
During operation, the green indicator 5
(and thus the heater) will continually turn
on and off. This serves to maintain as
constant a temperature as possible.
around 10 – 15 minutes.
the appliance to cool down.
the relevant information in the section
entitled "7. Cleaning and storage" on
page 9.
7