First Use; Putting On The Headset; Playback Settings; Settings On The Headset - Silvercrest SHIR 12 A1 Bedienungsanleitung

SilverCrest SHIR 12 A1

First use

Position the base (E) so that there are no objects between the base (E) and the headset (A).
Switch on the headset (A) with the on/off button (15).
Health risks due to high volume
Take care when using a headset. Listening at high volume for prolonged periods of time can
damage your hearing. Before putting on the headset (A), set the volume to the lowest level.
The playback volume is also influenced by the volume set on the audio source. First, set the volume
on the audio source to a low or medium level. It can be increased later if necessary.
Put on the headset (A).

Putting on the headset

Note the markings L (left) and
R (right) to put on the headset
(A) correctly. The headset (A) is
on correctly if the on/off button
(15) and balance control (5)
are pointing towards your
body.
As soon as the base (E) receives an audio signal, it is transmitted via an infrared signal to the
headset (A).
It is imperative that there is visual contact between the base (E) and the headset (A). First, set the
volume on your audio source to a pleasant level.

Playback settings

You have several options for adjusting the sound settings to suit your needs perfectly. When you
have put on the headset (A) and playback is in progress, make the following settings to it in order
to adjust the IR hearing amplifier perfectly to your hearing.
It makes sense to proceed in the sequence described below:

Settings on the headset

Volume
Adjust the playback volume according to your needs by turning the volume control (3). Set the
volume to the lowest level before putting on the headset (A). When you have put on the headset
(A) and playback is in progress, you then adjust the volume in order to find the setting that suits you
best.
English - 47