SilverCrest SHIR 12 A1
Charging the built-in battery
Before the first use or when the built-in battery is empty, you charge it as follows:
Connect the base (E) to the
mains
power
described above.
Place the headset (A) on the
base (E). The SilverCrest logo
must be facing forward.
The power LED (6) then lights
up orange on the base (E). The
battery is charging.
When the power LED (6) of the base (E) lights up green, the battery is fully charged and the
headset (A) is ready to use.
LED indicators
Base:
Power LED (6) lights up green,
headset (A) is not on base
Power LED (6) lights up orange,
headset (A) is on base
Power LED (6) lights up green,
headset (A) is on base
Audio LED (13) lights up orange
Audio LED (13) is out*
* If there is no audio signal for about 50-60 seconds, the base switches to energy-saving mode.
Headset:
Power LED (6) lights up orange
Power LED (6) is off*
* If there is no audio signal for about 90-120 seconds, the headset (A) switches to energy-saving
mode.
46 - English
supply
as
Base (E) is ready to use
Battery is charging
Battery is fully charged
Audio signal is being received
Energy-saving mode / no audio signal
Headset (A) is ready to use
Energy-saving mode