Handling; Branchements Et Éléments De Commande; Maintenance - Conrad i.Scratch Bedienungsanleitung

12. Handling

• Never connect the power plug to the wall outlet immediately after the device has been brought from a cold room
into a warm one. The condensation water created thereby may damage the device.
Allow the device to reach room temperature before connecting it. Wait until the condensation water has
evaporated.
• Never pull the mains plug by pulling the cable from the socket. Always only use the thus provided grip area.
• Remove the mains plug from the electrical outlet if the device is not in use for a longer period of time.
• For safety reasons always pull the mains plug from the socket during a thunderstorm.
• Music should not be listened to at an excessive volume for a longer period of time. This may damage your hearing.

13. Maintenance

Regularly check the technical safety of the CD player, for example, for damage to the mains cable or the housing.
If you have a reason to believe that the device can no longer be operated safely, disconnect it immediately and secure
it against being operated unintentionally. Pull the power plug out of the socket outlet !
It can be assumed that safe operation is no longer possible if:
• there is visible damage to the device or to the power line,
• the device no longer works
• it has been stored for a long time under unfavourable conditions
• it was exposed to extraordinary stress caused by transport
Before cleaning the CD player or performing maintenance work, the following safety instruction must be observed:
Live components may be exposed if the covering is opened or components are removed.
Therefore, disconnect the device from all voltage sources before performing maintenance work
or repairs.
Capacitors inside the device may still carry voltage even though they have been disconnected
from all voltage sources.
Repairs may only be carried out by qualified personnel who are familiar with the hazards
involved and the relevant regulations.
Otherwise, the CD tuner is maintenance-free. The outside should only be cleaned with a soft, dry cloth or a brush.
Never use caustic cleaning agents or chemical solutions as the surface of the housing could be damaged.
50
6. Branchements et éléments de commande
59