Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before first Use
Unpack the stirring machine and check all parts for any damage in transit.
Dispose of packaging materials or store it out of reach of children. Plastic bags
etc. may become a deadly toy for children.
Assembling
1. Screw the auxiliary handle (12) into the internal thread (B) on top of the
machine. For tightening, turn the auxiliary handle clockwise into the internal
thread.
Use the auxiliary handle at all times in order to maintain complete control of
the machine and to avoid injuries and damages!
2. Attach the bracket handle (5) to the star shaped collet at the rear side of the
machine and tighten the handle with the screw + nut (4). Tighten the screw
with a wrench size 13 and only turn hand tight.
You can also use the bracket handle to carry the machine. Always use the
handles to safety operate the machine and to control the high torque of the
machine.
Inserting the Tool
Make sure the mains plug is not plugged.
1. Open the drill chuck (10) by turning the chuck counter clockwise and insert
the desired tool. Close the drill chuck with the drill chuck key and only hand
tight the chuck. Do not use pliers or similar tool for tightening.
2. To close the jaws inside the drill chuck, turn the chuck clockwise.
Speed Controller
The stirring machine is equipped with an electronic speed controller (8). The
turning wheel is situated in front of the ON/OFF trigger.
Using the speed controller, you can adjust the revolution speed between
0 – 800 min
1. Turn the speed controller in direction plus (+) in order to increase the speed.
2. Turn the speed controller in direction minus (-) to decrease the speed.
-1
.
Operation
8
Werbung
Inhaltsverzeichnis
