Intended Use; Safety Information - Conrad 13 02 30 Bedienungsanleitung

DC Voltage Module
GB
Attention! You must read this!
Please read this user manual thoroughly. In the event of dama-
ges which arise due to non-observance of the user manual, any
guarantee claim will be void. Non-observance of this manual
may also result in danger to the user! We acc ept no liability for
consequential damage resulting from such non-observance!
Keep this user manual in a safe place.
List of contents

1. Intended use .............................................................................2

2. Introduction ..............................................................................3

3. Safety information ...................................................................3

4. Operating elements..................................................................6
5. Installation, settings, commissioning,
performing measurements ......................................................7
6. Technical data, measuring tolerances ...................................12
1. Intended use
• Measurement of direct voltages of 600 mV to max. 600 V
depending on range setting, through solder bridges). Without
solders a max. input voltage of 200 mV must not be exceeded.
• The panelmeter must not be operated without being installed
in an appropriate housing, switchboard, tableau or similar.
• Measurement in damp areas, outside, or in unfavourable envi-
ronmental conditions, is not permitted. Unfavourable environ-
2
mental conditions include:
- wetness or excessive air humidity,
- dust and combustible gases, vapours or solvents,
- strong vibrations,
- strong magnetic fields, as in the vicinity of machines or loud-
speakers,
- static electricity (fields and discharges).
Any use other than the one described above can lead to damage
to the product, and can also cause hazards, such as, for example,
short-circuit, fire, electric shock, etc.. No part of the product must
be modified or converted! The information must be observed!
Page
2. Introduction
The DC voltage module is a 3-
for simple measuring tasks. Despite its small dimensions, it is very
accurate and robust. It is intended to be used as a built-in instru-
ment in devices, switchboards (tableau) etc. (e.g. mains devices).
It can also be used as an independent voltmeter (in a housing!
Observe the safety regulations!) with appropriate prewiring (sol-
der bridges) up to max. 600 VDC. The polarity display, e.g. with
negative measuring signals, and the zero balance (offset) occur
automatically. Both the decimal point and the"mV" or "V" units
of measurement can be set using the corresponding settings insi-
de the panelmeter.
3. Safety information
• The DC voltage module is EMC and safety tested (CE) and the-
refore fulfils the EMC guideline 89/336/EEC and the low volta-
ge guideline 73/23/EEC.
• This unit is manufactured in accordance with VDE 0411 = IEC
1
/ -digit LCD built-in panelmeter
2
3