Siemens SIDOOR Betriebsanleitung Seite 36

13 Terminal circuit diagram of control inputs
Terminal circuit diagram of control inputs
Figure 13-1 Terminal circuit diagram of control inputs
Nudge = simultaneous activation of the CLOSE and Nudge commands (effective only in the closing direction).
Note
The X4 24V voltage output must not be connected to an external voltage potential, such as a higher-level elevator controller,
for example.
The X4 connector 2 (minus 24V) can be connected to the PE.
ATD400V hoisting and rolling shutter drive for elevators
36
A2B00101050-01, 07/2012