Hama Cyber Motion Bedienungsanleitung Seite 8

4.2. As gameport version (for Windows® 95/98)
In order to install your gamepad as gameport version (without adapter) proceed as follows:
• Run down your computer and switch it off.
• Connect your gamepad with the gameport of the PC (at most of the computers the gameport is at the
soundcard)
• Switch your PC on again and run it up.
• Put the CD into the CD Rom drive, click the start button, then "executing" and input the following:
D:\SETUP.EXE
("D" is the letter of your CD-Rom drive)
Then follow the instructions on your screen. After a re-start you have to activate the gamecontroller, i. e. the dri-
ver must be loaded into the system. Proceed as follows:
a) click the field "Start"
b) Choose "setting
c) Choose "system control"
d) Double click "gamecontroller".
e) Click "Add"
f) Choose "Digital 4D game pad (Gameport)"
g) Caution: click now "OK", not "Add"
If everything is installed correctly, "OK" disappears under "Status".
*** Attention ***
It is not recommended and necessary to calibrate the CompuPad Cybermotion. As this game pad works on a di-
gital basis (no analogue signals like a traditional game pad). A calibration can change the internal data base of
the device and the game can interprete the data wrongly which is transmitted by this device.
Part 5: Characteristics
1. The buttons and axes do not work properly during the test in the Windows ® game controller menu.
– This is normal. Due to the fact that some of the buttons are programed as keyboard buttons the drivers will
block the functions of the game input unit. Input the so-called Keystroke Scan Code for Windows® in order to
simulate the work of the keyboard.
2. Programming of the break button
If you program one button of the game pad with the break button the Num Lock button is passsed to the game.
How to simulate the problem: Open a profile. Choose one button of the gamepad that is.shown graphically at the
right side of the profile editor window. Safe and activate the profile. Press now the key on the game pad which
you programmed with the break function. You can see that the Num Lock LED goes on and out.
Recommendation:
Program no gamepad buttons with the Break button of the keyboard as the Num Lock will shine then. Please
note that this causes no damage to your gamepad, your software or your computer. The expected effect, howe-
ver, will not occur.
You can receive software updates at the website
http://www.hama.de/service_gb/download_sgb/joystick_sgb.html
Subject to technical changes!
48979/02.00