Troubleshooting - Bosch sensixx B10L Gebrauchsanleitung

Trouble shooting
Problem
The steam generator
does not come on.
The iron does not heat
up.
The iron begins to
smoke when switched
on.
Water flows through
the holes on the sole
plate.
Dirt comes out through
the sole plate.
The iron does not
produce any steam.
The ironed garment
turns dark and/or
sticks to the soleplate.
The soleplate turns
brown.
Loss of pressure
during ironing.
If the above does not solve the problem, get in touch with authorized technical service.
Possible causes
• There is a connection problem.
• The main power button is not
switched on.
• The main power button is not
switched on.
• The temperature control knob is set
to the «min» position.
• During first use: Certain components
on the appliance have been lightly
greased at the factory and may
produce a little smoke when initially
heated.
• During later use: the soleplate may
be soiled.
• The steam function is being used
before it has reached temperature.
• The water is condensing inside the
pipes because steam is being used
for the first time or has not been
used for a long time.
• There is a build-up of scale or
minerals in the boiler.
• Chemical products or additives have
been used.
• The boiler is not switched on or is
empty.
• The steam regulator is set to the
minimum position.
• The selected temperature is too high
and has damaged the garment.
• This is a regular consequence of
usage.
Steam release button activated during
a long period of time.
Solution
• Check the mains cable, the plug and
the socket.
• Switch the main power button (9) to
the on position.("I")
• Switch the main power button (9) to
the on position.("I")
• Set the temperature control knob
(11) to the desired position.
• This is completely normal and will
stop after a short while.
• Clean the soleplate according to the
cleaning instructions in this manual.
• Reduce the steam flow when ironing
at low temperatures (Variable steam
control (8)).
• Point the iron away from the ironing
area and press the steam release
button (12) until steam is produced.
• Clean the boiler
Use tap water mixed 50% with
distilled or demineralised water. If
the tap water in your district is very
hard, mix tap water with distilled
water 1:2.
• Clean the sole plate with a damp
cloth.
• Never add products to the boiler
• Switch the main power button (9)
to the on position.("I") and/or fill the
boiler
• Increase the steam flow by turning
the steam control (8).
• Select a suitable temperature for
the material and clean the sole plate
with a damp cloth.
• Clean the soleplate regularly with a
damp cloth.
Use the steam release button (12) with
intervals. This improves the ironing
result as the textiles will be dried and
stay smooth better.
en
13