Philips Fidelio DCW8010 Kurzanleitung

DCW8010
wireless music system with
AirPlay
Quick start guide
Always there to help you
Register your product for further support at
www.philips.com/welcome
AirPlay
Check your iOS version
Before using your product, read all accompanying safety information.
Lesen Sie vor der ersten Verwendung Ihres Produktes alle beiliegenden Sicherheitsinformationen.
Antes de usar el producto, lee toda la información adjunta a la de seguridad
Veuillez lire toutes les consignes de sécurité fournies avec votre produit avant de l'utiliser.
Settings
Upgrade your iPod touch, iPhone, or iPad to iOS
4.3 or above.
Note: Make sure that Wi-Fi is enabled on your
iPod touch, iPhone, or iPad.
Before setup, you are recommended to upgrade your
iPod touch/iPhone/iPad to the latest iOS version. For
iPhone 4S users, please upgrade to iOS 5.1 or above for
optimal performance.
If your router has a WPS button, you can connect the
device to the router through WPS.
a Press WIFI SETUP, then the light blinks green and
yellow alternately.
b Press the WPS button on your home Wi-Fi router.
e subject to change without notice
c Wait up to 2 minutes until the light stops blinking and
©2012 Koninklijke Philips Electronics N.V.
you hear a confirmation tone.
All rights reserved.
DCW8010_10_QSG_V1.2
Quick start guide
Option 1: Use iOS 5 Wi-Fi network login sharing (recommended)
Your Wi-Fi Network
5.X
Connect your iPod
touch/iPhone/iPad to your
home router by Wi-Fi.
Option 2: Set up through webpage configuration
X.X.X
General About
Wait for 35 seconds until the light in the middle
4.3
of the WIFI SETUP button turns to solid yellow.
192.168.1.1
Open Safari. Enter the IP address 192.168.1.1.
CD
USB
USB
PROG/
CLOCK
PROG/
CLOCK
Wait 35sec
WiFi SETUP
WiFi SETUP
Wait for 35 seconds until the light in the middle Dock your iPod touch/iPhone/iPad
of the WIFI SETUP button turns to solid yellow. onto the system.
Wait 35sec
WiFi SETUP
Wait<30sec
Open Settings. Wait up to 30 seconds until "Philips DCW8010
Tap Wi-Fi.
XXXXXX" is detected. Then, tap it.
Wait< 2min
a If it takes more than 2
minutes to see the screen of
step 8, try to turn on/off the
Airplane mode (Settings ->
Airplane Mode) and start
from step 2 again.
b If the problem remains,
restart your iPhone and start
from step 2 again.
Wait up to 2 minutes until the
Follow the on-screen instructions to
light stops flashing and you hear
configure the Wi-Fi settings for this system. a confirmation tone.
PROG/ 3 sec
CLOCK
MP3-LINK
Wait< 1min
Tap ALLOW (allow) to share your Wait up to 1 minute until the light
Wi-Fi settings with this system. stops flashing and you hear a
confirmation tone.
Philips DCW8010 XXXXXX
Remember to turn on
the 3G network after
successful AirPlay
Settings General Network
connection.
Disable the 3G network.
a If the light does not turn solid green after 2
minutes, reconnect the power adaptor, and then
repeat steps from beginning.
b To change Wi-Fi setup after first-time setup,
press and hold WIFI SETUP for more than 3
seconds to reset Wi-Fi settings. Then follow the
previous steps to change your network settings.
Your Wi-Fi Network
Open Settings. Check your router is selected. Open iPod application.
Philips DCW8010 XXXXXX
Tap AirPlay icon . Select this system. Tap to play music.
If the AirPlay icon does not appear or there is no sound output, try the following ways:
a Turn on and off the Airplane Mode in Settings.
b Restart your iPhone.
It is recommended to restart your home router.
c