Connecting The Input/ Output Terminals - Pioneer DJM-350 Bedienungsanleitung

Connecting the input/ output terminals

! When creating a DVS (Digital Vinyl System) combining a computer, audio interface, etc., be careful in connecting the audio interface to this unit's
input terminals and in the settings of the input selector switches.
Also refer to the operating instructions of the DJ software and audio interface.
Rear panel
R L
L
R
AUDIO
OUT
CONTROL
USB
Example:
CDJ-350
DJ player
1 To use the fader start function, connect a control cord (page 10).
The fader start function can only be used when connected to a Pioneer DJ player.
2 A portable audio device can be connected using an RCA pin - mini-plug (Ø 3.5 mm) converter cable (page 11).
Front panel
Headphones
Headphones cord
To power outlet
Power cord (included)
AC IN
Audio output section
Audio cable
Control cord 1
To ground To audio
wire terminals output terminals
Analog player
Component, amplifier,
powered speaker, etc.
Audio cable To audio input terminals
Audio input section
MASTER OUT CH-2
1 PHONO
2 CD
L L
L L
CONTROL
R R
R R
Ground wire
Audio cable
To audio
output terminals
Portable
Microphone
audio
device
SIGNAL
GND
CH-1 AUX
PHONO
CD
L
L
MIC
L L
CONTROL
R R
R
R
Audio cable 2
Microphone
cable
To microphone
7
En