Connections; Names Of Terminals; Rear Panel; Front Panel - Pioneer DJM-350 Bedienungsanleitung

Connections

Be sure to turn off the power and unplug the power cord from the power outlet whenever making or changing connections.
Refer to the operating instructions for the component to be connected.
Connect the power cord after all the connections between devices have been completed.
Be sure to use the included power cord.

Names of terminals

Rear panel

1 AC IN
Connect to an AC outlet. Plug in the power cord after all connections
have been made.
Be sure to use the included power cord.
2 MASTER OUT 1, 2 (page 7)
Connect to a power amplifier, etc.
3 PHONO (page 7)
Connect to an analog player or other phono level (MM cartridge)
output device. Do not connect to a DJ player or other line level device.
4 CD (page 7)
Connect to a DJ player or other line level device.

Front panel

a PHONES (page 7)
Connect headphones here.
6
En
MASTER OUT
1 2
AC IN
L
R
1 2
a
SIGNAL
GND
CH-2 CH-1
PHONO CD PHONO CD
L L
CONTROL CONTROL
R R
3 4 5 6 3 4 5
5 CONTROL (page 7)
Connect using a control cord (included with Pioneer DJ players).
6 SIGNAL GND (page 7)
Connect an analog player's ground wire here. This helps reduce
noise when the analog player is connected.
7 AUX (page 7)
Connect to the output terminal of an external device (sampler, por-
table audio device, etc.)
8 MIC (page 7)
Connect to a microphone.
9 Kensington security slot
AUX
L
MIC
R
7 8 9