Connecting The Receiver - Medion MD 24019 Bedienungsanleitung

Connecting the receiver

The following connections must be made before you can use the receiver unit to watch
digital TV. On the backside of the receiver you will find the following markings. Please follow
these steps for the correct setup of the receiver unit:
TV-SCART Connect your TV to the TV SCART connector/jack using the supplied
Euro SCART cable. For best results we recommend using a double-
coated high quality shielded Euro SCART cable.
RF-IN Connect the cable of your satellite TV system to this connector.
power cable Connect this moulded power cable and socket to an available power
socket.
Optional devices
L/R (AUDIO) If you wish to hear superior sound through your Hi-Fi Stereo system
you can do so by using a stereo-cinch-cable. Please pay attention that
the audio channels of your stereo system are connected to the correct
connectors (L/R to L/R).
VCR-SCART Connect your VCR here.
SPDIF For the best possible sound reproduction – Digital audio output.
Connect your amplifier with an S/PDIF IN socket using this connection.
If the amplifier has an optical S/PDIF IN socket you can use an optical
cable to connect to the SPDIF OPTICAL socket on the receiver. If the
amplifier has a coaxial S/PDIF IN socket you can use a shielded coax-
ial cable to connect to the SPDIF COAXIAL socket.
VIDEO Composite video out. Connect to your TV or VCR. Your TV or VCR must
support Composite IN (check your TV / VCR user manual). A composite
video cable is not included.
SVIDEO Y/C video out. Connect to your TV or VCR. Your TV or VCR must support
S-Video IN (check your TV / VCR user manual). This gives better pic-
ture quality than the Composite video signal. A composite video cable
is not included.
Y U V RGB / YUV video out for best picture quality. Connect the connectors
to a flat panel or video projector. This delivers the best possible video
quality. Note: Sometimes on other products the YUV signal is labelled
as YCrCb. If you are using the connectors in RGB mode please follow
the colours of the connectors.
RX/TX For authorised service use ONLY.
58 MD 24019