Channel Search; Automatic Channel Search - Siemens Gigaset M270T Bedienungsanleitung

3. Specify your preferred frequencies and channels. Go to Start Scan and confirm your
selection.
The device then initiates an automatic channel search.
4. Follow the instructions as displayed on the screen until initial installation is
completed, the device then changes to TV operation.

Channel search

For a start we recommend to have an automatic search done as this scan mode normally
detects all channels available. The expert scan mode enables the specific search for an
individual channel. This in particular makes sense if you only want to include one
individual channel into your channel list and you know the information on the channel
and frequency.
In the course of scanning already detected channels are added to a list, two displays
informing you on signal strength and quality.
Note: You may cancel scanning at any time by pressing

Automatic channel search

...
> Search for Channels > Automatic Search
Note: If feasible at all, leave the scanning values unchanged, as the defaulted values
generally guarantee the detection of all channels.
1. Choose those channels to be searched for (recommended: All).
Note: We generally advise you to search for all channels and to not alter the defaulted
values.
2. Select Start Scan and confirm your selection.
Following the scanning procedure a dialog informs you on the completion of the
search.
3. Specify whether the found channels should add to the current channel list or replace
the former list or whether you want the newly detected channels to be discarded.
Confirm your selection.
!
4. Pressing once makes you quit the scan menu and return to the overview. The
repeated activation hides the OSD.
Note: If no channels were found at all check the antenna cable for correct connection.
Expert scan mode
...
> Search for Channels > Manual Search
1. Implement all required settings.
The numerical buttons enable for input of the frequency. In addition, you can
preselect the channels to be searched for by activating the Channels to search for
function (e.g. for all channels Free to air).
2. Then select Start Scan and and confirm your selection.
Operation
!
.
9