Hama BC300 Bedienungsanleitung Seite 8

AC Adaptor:
The AC Adaptors are low voltage power source that allow you to use
your household electricity to run the Baby Monitor. Connect the AC
Adaptors to the AC Adaptor Jack in the Parents and Baby Unit. Both
plug into any standard volt electrical outlet in your home. It is
recommended to turn off the units before plug in or unplug the
adaptors.
CAUTION: These adaptors were made with a specific design for this
product. They cannot be used with any other appliance. Never use a
different type of adaptor with Baby Monitor.
CAUTION
This product cannot replace responsible adult supervision.
• This Baby Monitor is intended as an aid. Do not use it as a medical monitor or
a substitute for responsible and proper adult supervision.
• Make sure the Receiver and adaptor cable are always out of child's reach. Do
not place the Receiver inside the baby's crib or playpen!
• The antenna on the Units are fixed, do not try to extend them. Never attempt to
modify the product.
• Avoid using the product near water and expose to rain or moisture.
Receiver & Transmitter Battery Installation
1. Locate the battery compartment door on the
back of the Units.
2. Open the battery compartment door.
3. Insert 3 * AAA batteries into the Receiver and
the Transmitter according to the +/- signs shown
in the battery compartment, respectively.
4. Replace battery compartment doors.
Battery Tips:
• If the product is not in use for a long time, disconnect both units from the
household electrical outlet. And remove the batteries or the exhausted
batteries from the units, otherwise battery leakage and corrosion can damage
them.
16
• Non-rechargeable battery is not to be recharged
• Rechargeable batteries are only to be charged under adult supervision.
• CAUTION: Danger of explosion if battery is incorrectly replaced. Replace
only with the batteries of the same and equivalent type.
Transmitter & Receiver Battery Charging
If the battery level becomes low, in both LCD displays the empty battery icon.The
battery icon and the out of range alarm icon flash, in order to warn you about the
low battery level. The receiver also emits a warning tone continually.
Charging the batteries
Please charge the rechargeable batteries first time usage.
The rechargeable batteries to the transmitter and receiver must not be taken out
of the units for charging. The battery icon loops and flashes while charging. It
stops flashing when the batteries are fully charged.
Charging the transmitter
1. Connect the power supply unit to the thin plug on the 6V-socket of the
transmitter.
2. Once the power supply unit is connected to the transmitter, charging
automatically begins.
3. The charging time for completely charging empty battery takes about 9 hours
when the transmitter is turned off.
Charging the receiver
1. Connect the power supply unit to the thick plug on the charger stand socket.
2. Once the power supply unit is connected to the charger stand and the receiver
is on the charger stand, charging automatically begins.
3. The charging time for completely empty batteries and turned off unit is
about 9 hours.
Remarks:
1. Use only the DC adaptors or desktop charger stand which are included in the
package. Plug into any nearby standard household electrical outlet.
17