Assembly Instruction - Westfalia 81 34 27 Bedienungsanleitung

6. Attach the assembled tabletop support to
the worktop (11). Use the hex-head screws
(6xJ), the washers (6xN) and the lock nuts
(6xG) (figure 4).
Note: Pay attention that the pull handle (4) is
facing in the same direction as the threaded
holes for the locking wheels (5). This way
the table can be folded more easily in case
you want to move it.
7. Attach the casters (2xB) using the hex-head
screws (2xI), the washers (2xN) and the lock
nuts (2xG). Only fasten the lock nuts hand
tight so the casters still can run freely
(figure 5). Attach the four foot caps (7) to
the table leg ends.
8. Adjust the table to the desired working
height. Fix this position with the two cotter
pins (9) and the locking wheels (5). Lead the
thread of the locking wheel through the ring
of the chain (figure 6).
9. Use the wing nuts (4xE) and the washers
(4xN), as pictured, to mount the two retract-
able guide rails (1) and (3) to the sides of
the worktop (figure 7).

Assembly Instruction

10
4
5
6
7