Westfalia 81 34 27 Bedienungsanleitung Seite 14

Tools required for Assembling
10 mm & 13 mm wrenches or ratchet wrenches
cross-head screwdrivers
Before assembling check the material for completeness (refer to overview).
Assembling
1. Place the worktop (11) upside down on a flat
level surface (e.g. workbench).
2. Put the washers (6xF) onto the corresponding
holes of the worktop and mount the two bear-
ings using the hex-head screws (6xM), the
washers (6xP) and the lock nuts (6xH)
(figure 1).
3. Insert the extensions (13) into the correspond-
ing slots of the table legs and screw the locking
levers (2xA) onto the extensions (figure 2).
4. Attach the two cross braces (12) and the tool
holder (6) using the cross-head screws (10xK),
the washers (10xP) and the nuts (10xO). This
way you assemble the tabletop support.
5. Now attach the upper cross brace using the
cross-head screws (4xL), the washers (4xP)
and the nuts (4xO) (figure 3).
Assembly Instruction
9
1
2
3