Appliance Self-Test; Starting The Appliance Self-Test - Bosch KSW Series Gebrauchsanleitung

Fault
Appliance is not cooling,
temperature display and light
are lit.
Water dispenser is not
functioning.
Water dispenser is not
functioning.
The "lock" and "on/off"
buttons flash.

Appliance self-test

Your appliance features an automatic
self-test program which shows you
sources of faults which may be repaired
by customer service only.

Starting the appliance self-test

m
Caution
To prevent the self-test from
■
terminating, keep the appliance door
closed while the self-test program is
running.
As water or ice may be dispensed
■
during the test, keep a glass in the
dispenser unit while the self-test is
running.
Possible cause
Showroom mode is
switched on.
Tap turned off.
Filter on the water
connection is dirty.
Water supply is interrupted.
Water pressure too low.
Supply hose is kinked or
crushed. Fig. .
Water has escaped from the
pipe system.
The integrated AquaStop
system has interrupted the
water supply.
Remedial action
Hold down alarm button, Fig "/5, for
10 seconds until an acknowledgement signal
sounds.
After a short time check whether your
appliance is cooling.
Turn the tap on.
Clean the filter.
Inform plumber.
Ensure that the supply hose is installed
correctly.
Turn off the water supply and inform customer
service (see chapter entitled "Alarm function").
1. Switch off the appliance and wait
5 minutes.
2. Switch the appliance on. If a warning
signal sounds, it will automatically
switch off as the self-test progresses.
3. Within the first 10 seconds after
switching on the appliance, hold down
the super button, Fig. "/2, for 3 to 5
seconds until an acoustic signal
sounds. Then immediately close the
door.
The self-test programme starts. While
the self-test is running, a long acoustic
signal sounds once and the controls
on the dispenser unit flash.
en
37