Technical Assistance - Warranty - Philips WelcomeEye Connect Anleitung

8. TECHNICAL ASSISTANCE - WARRANTY

The FAQ is available in the complete instructions, which can be downloaded at
www.philips.com.
This product is guaranteed for parts and labour in our workshops.
The warranty does not cover: consumables (batteries, etc.) and damage caused by misuse,
improper use, improper installation, external intervention, damage due to physical or
electrical shocks, dropping, or atmospheric phenomena.
• Do not open the device, as this will void the warranty.
• If the unit is returned for After Sales Service, protect the unit to prevent scratches.
• Clean with a soft cloth only, no solvents. The guarantee is void if parts have been
dismantled. Before cleaning it, disconnect the equipment or switch it off at the mains.
Warning:
Do not use any gasoline or carboxylic acid, alcohol or similar treatment. In
addition to damaging your device, the fumes are also hazardous to your health and are
explosive.
Do not use any tool that can conduct voltage (wire brush or other sharp tool, etc.) for
cleaning.
The till receipt or invoice is your proof of purchase date.
If you need assistance, our contact information and call centre opening hours are available
on our website, www.philips.com.
WARRANTY CARD
Mr / Mrs :
Phone number :
Address :
E-mail :
Date of purchase :
Dealer :
Dealer Phone :
Dealer address :
Serial number PHI/1031/
Important : Please keep this warranty card with your proof of
purchase.
Philips and the Philips blue shield are registered trademarks of Koninklijke Philips N.V.
and are used under license. This product was manufactured by and is sold under the
responsibility of CFI Extel SAS. CFI Extel is the sole guarantor of the product.
GB11
/ / (DD/MM/YYYY)
WelcomeEye Connect / Touch / 08/17