Installing A Camera (Optional); Get More Out Of Your Device; Technical Characteristics - Philips WelcomeEye Connect Anleitung

accordance with current standards, NFC 15-100 in France)
- Check the device is working (video call, RFID).
- If you have a second intercom panel, you should configure the monitor(s).
11 - Attach a silicone seal* between the shield and the wall to stop flowing water. *Do not
use acetic acid-based silicone (vinegar odour).

5. Installing a camera (optional)

Connect the wires according to the wiring diagram.
Choose a suitable place to install the camera.
Ensure that nothing is obstructing the installation.
Screw the wall section with the screws provided (for solid walls).
Point the camera in the desired direction and tighten the lateral retainer screw.
Configure the monitor(s)

6. Get more out of your device

To discover more features of your Philips WelcomeEye product, you can download the
complete instructions on our website www.philips.com.

6. TECHNICAL CHARACTERISTICS

Monitor
ref: 538102 (WelcomeEye Connect)
ref: 538101 (WelcomeEye Touch)
- 2 wires
- 7" Touchscreen
- 800 x 480 Resolution
- Micro SD card class 10 up to 32Go (not provided)
- 2.4 GHz WiFi IEEE 8111 b/g/n (for WelcomeEye Connect only)
- Radio signal strength: 18 dB maximum
- Current consumption: 550mA (Connect), 470mA (Touch)
- Power consumption: 13.2W (Connect), 11.3W (Touch)
- 6 chimes (85dB)
- Dimensions: 142 (h) x 210 (w) x 15 (d) mm
Intercom panel (WelcomeEye Outdoor)
ref: 531006
- C-MOS colour sensor 900TVL
- Viewing angle - 130°H, 90°V
- Night vision (white LEDs)
- Strike plate control 12V/1.1A
- Gate control: breaking capacity: 12 V/2 A
- RFID (125kHz)
- IP44
- operating temperature: -20°C / +50°C
- Dimensions: 168 (h) x 82 (w) x 38 (d) mm
WelcomeEye application (for WelcomeEye Connect only):
- Android: v4.4 or higher
GB9
On
WelcomeEye Connect / Touch / 08/17
On