Hama Premium Bedienungsanleitung Seite 5

Risk of electric shock
• Do not open the product. Do not continue to
operate the product if it is damaged, which may
be indicated by smoke, odour or loud noises.
Immediately contact your dealer or our service
department (see item "Service and Support").
• Do not attempt to service or repair the product
yourself. Leave any and all service work to
qualified experts.
• The rechargeable battery may only be replaced
by an authorised technician.
4. Getting Started
With the digital weekly timer switch (also referred to
below as the "timer" or "timer switch"), you can set
user-defined switch-on and switch-off times for your
electric devices.
Note
• If the timer cannot be put into operation, press
and hold the RESET button for a few seconds.
• The device contains a rechargeable battery.
This ensures that the time continues to run
even if the timer switch is not plugged into an
electrical socket. The times that have already
been programmed also remain saved.
• The rechargeable battery is charged during
operation.
• The internal rechargeable battery will discharge
if the timer switch is not used for longer periods
of time. Plug the timer switch into a mains plug
for approx. 24 hours every 3 months to charge
the internal rechargeable battery.
4.1 Setting the time and day of the week
You can choose to display the time in 12-hour or
24-hour format.
In 24-hour mode, the time runs from 0:00 to 23:59.
In 12-hour mode, the clock differentiates between
morning (AM) and afternoon (PM) hours:
Morning – AM –
00:00 AM to 12:59 AM
Afternoon/evening – PM –
01:00 PM to 11:59 PM
• Simultaneously press the CLOCK / OK and PROG
buttons to switch between the two time display
modes.
• To set the current time and the day of the week,
hold down the CLOCK / OK button for three
seconds. CLOCK, HOURS, MINUTES and WEEKS
are displayed on the LCD. You are now in entry
mode.
• When you press the SET button, a small triangle in
front of the HOURS display begins to flash. Enter
the current hour by pressing UP / CLEAR.
• To switch to the minute setting, press SET again.
A small triangle in front of the MINUTES display
flashes. Press the UP / CLEAR button until the
desired minute value is displayed.
• After you have entered the time, you can select the
day of the week. To do so, press the SET button
again. The small triangle in front of WEEKS begins
to flash, signalling that the device is ready for your
entry. Select the day in the same way as the time,
using UP / CLEAR.
• Once you have entered all data correctly, press
CLOCK / OK. This causes you to exit entry mode.
• If no button is pressed for an extended period of
time when you are entering the time or day of the
week, the timer switch automatically exits entry
mode. The last confirmed entries are applied.
Special summer time feature
• You can switch between winter time and summer
time by simultaneously pressing the CLOCK and
SET buttons. Summer time is indicated on the
display by SUMMER , meaning that the time has
been automatically set one hour ahead of winter
time.
• The switch-on and switch-off times that have
been set remain unchanged and must be adjusted
manually to summer time if required.
3