Inserting/Replacing The Batteries; Using - Westfalia 82 72 67 Bedienungsanleitung

Inserting/Replacing the Batteries

The battery compartment (7) is located at the rear side of the digital
spirit level.
1. Depress the latch of the battery compartment lid and open the
battery compartment.
2. Insert 2 new batteries (not included) of the type LR03 (AAA) into
the battery compartment. Pay attention to the proper polarity of
the batteries. The polarity is printed inside the battery compart-
ment.
3. Close the battery compartment with the lid.
Note: Replace the batteries if the display gets weaker, if it shows
incomprehensible results or if the battery icon
the display.

Using

Use the digital spirit level as a "regular" spirit level using the vertical
level tube (2) or the horizontal level tube (3). Or use the device as
precise digital spirit level as follows:
On/Off Key ON/REF/OFF (9)
 Briefly press the On/Off key (9) to switch on the digital spirit level.
During a short self-test, all icons are shown on the display.
 Hold the digital spirit level to the object to be measured and read
the measured angle on the display (5).
 Note: If you tilt the digital spirit level in an angle > 90º, the display
automatically flips over by 180º for better readability.
 Briefly press the On/Off key to toggle between displaying the
absolute angle and displaying the relative angle/the deviation of
the angle (display shows REF). When switching to the REF
mode, the device resets the display to zero degrees. The follow-
ing measurement readings refer to this zero reference point.
Operation
11
appears on