Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Ratchet Puller
Capacity 1500 kg
Extended Length: 90 cm
Operating Instructions:
1. Pulling loads
Hook the spiral spring between the hook in the handle and the eye on
the drive ratchet.
The steel rope is wound up by moving the handle back and forth.
2. Loosening the rope
Remove the spring between the handle and the drive ratchet.
Move the handle to the side up to the stop where the 2nd hook is
attached.
This loosens the ratchet and the rope is released.
3. By holding the catch the rope can be unrolled manually.
Please observe the safety information below:
•
The unit is for pulling only, not for lifting loads.
•
Regularly check the steel rope for kinks, twists and broken strands.
•
Do not pull the rope over edges or around corners.
•
Do not use the steel rope for attaching loads by wrapping it round
them.
•
Do not overload the jack.
•
Do not extend the handle by means or pipes or similar.
•
Do not unroll the steel rope from the spool under load.
Dear Customers
III
Werbung
