Genlock Menu; Cable Menu - JVC RM-P210 Bedienungsanleitung

MENU OPERATION

GENLOCK MENU

This menu is used to set the camera cable length to the length actually used.
( REF. : "Adjustments for Genlock Operation" on page 12.)
No. Item
1A H PHASE
1B SC COARSE
1C SC FINE
1Z BACK

CABLE MENU

This menu sets the camera cable length according to the actual length used.
( REF. : "Camera Cable Length Setup" on page 11.)
No. Item
2A LENGTH
2B Y CABLE EQ
2C C CABLE EQ
2Z BACK
E-20
Function, Operation
Adjustment of the Horizontal sync phase of genlocking.
Coarse adjustment of the colour phase of genlocking.
Use a vectorscope, etc.
Fine adjustment of the colour phase, which should be performed
after completing the SC COARSE adjustment.
If the subcarrier cannot be adjusted with SC FINE, restart the
adjustment from SC COARSE.
Return to the previous display.
Function, Operation
Set according to the total length of the camera cables in use.
Fine adjustment of the luminance signal.
Fine adjustment of the chrominace component.
NOTE
This adjustment causes the phase to be altered. Be sure to
adjust SC FINE after this adjustment.
Return to the previous display.
Available Settings Initial Setting
0 to 255 128
0°, 90°, 0°
180°, 270°
0 to 255 128
– –
Available Settings Initial Setting
5M, 20M, 20M
50M, 100M
-128 to NORMAL
NORMAL to
127
-128 to NORMAL
NORMAL to
127
– –