Operation - Kärcher BR 60/95 RS Bp Pack Bedienungsanleitung

Pushing the device
While standing, the device is protected
against rolling off with the help of an electri-
cal immobilising brake. To push the device,
you need to first unlock the immobilising
brake.
Press the unlocking lever downward to
unlock the immobilising brake.
Danger
Risk of accident if the device rolls off. Apply
the immobilising brake again immediately
after finishing pushing the machine by
pushing the unlocking lever upward.
Unloading
Note
Take the foot off the aceelerator pedal,
press the emergency-stop button to imme-
diately deactivate all functions and turn the
key switch to the "0" position.
Loosen the screws and remove the
wooden cage.
Cut plastic packing belt and remove foil.
Loosen the fixing at the wheels.
Place the boards on the edge of the pal-
let. Place the boards in such a way that
they lie in front of the four wheels of the
machine. Fasten the boards with
screws.
Remove the wooden blocks used for ar-
resting the wheels and slide them under
the ramp.
Insert the steering wheel and straight-
align the front wheel.
Pull out the steering wheel, align and in-
sert back.
Fasten the steering wheel using en-
closed nut.
Insert the cover in the steering wheel.
Get on to the standing area and keep
the safety pedal depressed with the left
foot.
Release emergency-stop button by
turning.
Set main switch to "1".
Set the drive direction using the drive di-
rection button at the operator console.
Select the smallest speed range using
the speed button.
Press the unlocking key.
To drive, press the accelerator pedal
carefully and drive down slowly from the
palette.
Set main switch to "0".
18 English
Installing the Brushes
The brushes must be installed before the in-
itial operation (see "Maintenance works").

Operation

Danger
Long hours of using the appliance can
cause circulation problems in the hands on
account of vibrations.
It is not possible to specify a generally valid
operation time, since this depends on sev-
eral factors:
– Proneness to blood circulation deficien-
cies (cold, numb fingers).
– Low ambient temperature. Wear warm
gloves to protect hands.
– A firm grip impedes blood circulation.
– Continuous operation is worse than an
operation interrupted by pauses.
In case of regular, long-term operation of
the device and in case of repeated occur-
rence of the symptoms (e.g. cold, numb fin-
gers) please consult a physician.
Note
Take the foot off the aceelerator pedal,
press the emergency-stop button to imme-
diately deactivate all functions and turn the
key switch to the "0" position.
Carry out maintenance jobs "Before
starting working week" (see section
"Maintenance and Care").
Check immobilizing brake
Danger
Danger of accident. The immobilizing brake
must always be checked first on an even
surface before starting the machine.
Set main switch to "0".
Press emergency-stop button.
If the appliance can be moved by hand, the
parking brake is not engaged.
Pull up the reset lever of the parking
break.
If the appliance can still be moved by hand,
the parking break is defective. Shut down
the appliance and call Customer Service.
Brakes
Danger
Danger of accident. If the appliance cannot
brake adequately while going downhill,
press the emergency stop button.
Filling in detergents
Fresh water
Open the cover of the fresh water reser-
voir.
Fill fresh water (max. 60 °C) until 15 cm
below the upper edge of the tank.
Pour in detergent.
Close the cover of the fresh water reser-
voir.
Note
Fill up the fresh water tank completely be-
fore starting up the machine to ventilate the
water supply system.
If the pipe system is empty, it can take
about 2 minutes till the detergent solution
comes out of the cleaning head.
Detergent
Warning
Risk of damage. Only use the recommend-
ed detergents. With respect to different de-
tergents the operator bears the increased
risk regarding the operational safety and
danger of accident.
Only use detergents that are free from sol-
vents, hydrochloric acid and hydrofluoric
acid.
Note
Do not use highly foaming detergents.
Recommended detergents:
Application
Routine cleaning of all wa-
ter resistant floors
Routine cleaning of glossy
surfaces (e.g. granite)
Routine cleaning and ba-
sic cleaning of industrial
floors
Routine cleaning and ba-
sic cleaning of fine stone-
ware tiles
Routine cleaning of tiles in
sanitary areas
Cleaning and disinfection
in sanitary areas
Removal of coating from
all alkali-resistant floors
(e.g. PVC)
Removal of coating from li-
noleum floors
Driving
Carry out the initial trials in an open surface
so that you familiarise yourself with the ap-
pliance.
Danger
Danger of tipping if gradient is too high.
The gradient in the direction of travel
should not exceed 10%.
Danger of tipping when driving round bends
at high speed.
Danger of slipping on wet floors.
Drive slowly when cornering.
Danger of tipping on unstable ground.
Only use the machine on sound surfac-
es.
Danger of tipping with excessive sideways
tilt.
The gradient perpendicular to the direc-
tion of travel should not exceed 10%.
Get on to the standing area and keep
the safety pedal depressed with the left
foot.
Do not press the accelerator pedal.
Release emergency-stop button by
turning.
Set main switch to "1".
Detergent
RM 780
RM 746
RM 755 es
RM 69 ASF
RM 753
RM 751
RM 732
RM 752
RM 754