IKEA LAGAN Bedienungsanleitung Seite 10

ENGLISH
German degrees
(°dH)
<4
1) Factory setting.
2) Do not use salt at this level.
Whether you use a standard detergent or
multi-tabs (with or without salt), set the
proper water hardness level to keep the
salt refill indicator active.
Multi-tabs containing salt are not
effective enough to soften hard
water.
How to set the water softener level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
the programme button until the
indicator flashes and the indicators
and are on.
2. Wait until the indicators
are off and the indicator
The indicator
intermittent flashing of the indicator
shows the current setting.
• e.g. 5 flashes + pause + 5 flashes =
level 5.
3. Press programme button repeatedly to
change the setting. Each pressing of the
programme button increases the level
number. After reaching level 10, the
count starts again from level 1.
4. Press the on/off button to confirm the
setting.
Acoustic signals
Acoustic signals sound when a malfunction
of the appliance occurs. It is not possible to
deactivate these acoustic signals.
French degrees
(°fH)
<7
and
flashes.
still flashes. The
mmol/l Clarke de-
grees
<0.7
There is also an acoustic signal that sounds
when the programme is completed. By
default, this acoustic signal is activated and
it is possible to deactivate it.
In addition, an acoustic signal will sound
before the AutoOpen will open the door.
This acoustic signal stops only if AutoOpen
is deactivated.
How to deactivate the acoustic signal for
the end of programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
the programme button until the
indicator
and
2. Press the programme button
immediately.
• The indicator
• The indicator
3. Wait until the indicator
are off. The indicator
• The
setting:
4. Press the programme button to change
the setting.
• off = Acoustic signal off.
5. Press on/off confirm the setting.
AutoOpen
AutoOpen improves the drying results with
less energy consumption.
Water softener level
< 5
1
flashes and indicators
are on.
and
flashes.
and
still flashes.
indicator shows the current
on = Acoustic signal on.
10
2)
are on.